Compressed Air

Measure	Incentive
Air compressor VFD <200 hp	$200 per hp
Low-pressure drop filter	$10 per hp
No-loss condensate drain	$200 per unit
Efficient compressed-air nozzle	$80 per unit

Motor

Measure	Incentive
Wall- or engine-mounted engine block heater control	$100 or $150 per unit
Notched V-belt	$5 per hp (max $50 per motor)
High-efficiency battery charger for forklifts	$200 per unit

Fans

Measure	Incentive
High-volume, low-speed fan	$2,000 per fan

Dairy

Measure	Incentive
VFD on milking vacuum pump	$250 per hp
VFD on dairy milk transfer pump	$1,500 per VFD

Laundry

Measure	Incentive
ENERGY STAR washer*	$200 per washer

*Must be paired with an electric dryer

While every effort has been made to ensure accurate calculations in the worksheet, Idaho Power will make the necessary adjustments to ensure correct incentive payment if errors are found.

• Non-Lighting Application (Updated Sept. 5, 2023)
• Other Commercial Incentives and Worksheet (Updated Sept. 5, 2023)

If your project doesn’t fall within our menu of incentives, we may be able to offer an incentive of 18 cents per kilowatt hour saved, up to 70% of the eligible project cost for other qualifying custom projects.

Pre-Approval Application Process

Pre-approval is needed for projects with estimated incentives of $2,000 or greater. Obtain pre-approval from Idaho Power before the project begins.

1. Download the applicable worksheet from the Application and Worksheets section and enter your project’s information.
2. Download, fill out, sign and date the Non-Lighting Application.
3. Gather manufacturer specification sheets for equipment to be installed.
4. Email the above items to retrofit@cjpk.net.
5. Idaho Power reviews the submitted paperwork and sends written pre-approval via email.

Payment Application Process

Submit a Non-Lighting Application within 90 days of project completion.

1. If your project was not pre-approved, download the applicable worksheet from the Application and Worksheets section and enter your project’s information. If your project was pre-approved, use the same worksheet you submitted at pre-approval (edit as necessary to reflect actual project).
2. If your project was not pre-approved, download, fill out, sign and date the Non-Lighting Application. If your project was pre-approved, use the application submitted for pre-approval and mark “Payment” in the box at the top of the page.
3. Gather detailed labor and material invoices.
4. For projects that did not require pre-approval, submit the manufacturer specification sheets for the installed equipment.
5. Email the above items to retrofit@cjpk.net.
6. Idaho Power reviews the submitted paperwork and processes the incentive payment.

NOTE: Idaho Power reserves the right to perform a site inspection. You or your contractor will be notified if your project is selected for inspection.